This 7KW intelligent AC charging pile based on the latest CCS international charging standards . Maximum charging current can be up to 32 A, using RFID start charging , anti-theft security . Meet the needs of the type 2 electric vehicle charging . Charging in accordance with international safety standards , has passed the CE safety test .
UPGRADE YOUR GARAGE OR DRIVEWAY WITH
The charger can be installed inside or outside, on a wall or a special installation pole. Despite being among the most compact on the market, it packs all the necessary equipment for safe charging. The charging cable can be neatly folded on the plug holder to keep it in place and readily available.
Apply to Vehicle
Chevrolet Volt, Citroen C-Zero, Fisker Karma, Ford Focus Electric, Ford C-Max Energi, Mia, Mia Electric Van, Mitsubishi-I Miev, Mitsubishi Outlander Phev, Nissan NV200 SE Van, Nissan Leaf, Peugeot Ion, Renault Fluence, Renault Kangoo, Smiths Edison Van, Smiths Newton, Tata Indica Vista EV, Toyota Prius, Vauxhall Ampera...
Equipment Specification Table
Power Input | Input Rating | 230V ±10% 50-60Hz |
Power Output | Phase / Wire | 1-phase / L, N ,PE |
Output Voltage | AC110-230V | |
Output Current | 0-32 A | |
Current THD | ≤5% | |
Total Power | 7.4 kW | |
Protection
| Protection | Over current, Under voltage, Over voltage, Residual current, Surge protection, |
Short circuit,Over temperature, Ground fault | ||
Control | Push Buttons | Emergency stop button (Red) |
Charge Options | Charge options to be provided upon request: Charge by duration, Charge by energy | |
Charging Interface | Type 2 | |
Communication | User Authentication | ISO14443 Type A/B RFID for user authentication (13.54MHz) |
Environmental | Operating Temperature | -35℃~65℃ |
Storage Temperature | -40 ℃ to +70 ℃ | |
Humidity | <95% relative humidity, non-condensing | |
Altitude | ≤6000 feet (2000 m) | |
Mechanical | Ingress Protection | IP55 |
Enclosure Protection against | IK10 according to IEC 62262 | |
Weight | 4.2 kgs | |
Socket | Mode 3(IEC 61851) | |
Outer Casing | Monocoque shell made from 1.5 mm Stainless, Powder Coated Steel | |
Dimension (W x H x D) | 316mm*197mm*80mm | |
Regulation | Certificate / Compliance | CE / IEC 61851.1-2017, IEC 62196-3 |
Features:
Outdoor rated enclosure with rugged all-weather steel housing
High compatibility.It can charge all EVs manufactured in Europe and USA, correctly and effectively.
Shows charging status via screen.
Easy to install . Products are sent to you with associated installation tools
This product is small and exquisite, and thus it is very easy to transport, store and install.
Intuitive plug and charge interface
User friendly LEDs to display status like charging.
Low operational noise
Advanced safe & efficient AC charging system
RFID system to control ON/OFF
Customized branding (optional) or OEM service
Products are sent to you with associated installation tools. You are able to install the charger indoor or outdoor.
irmly locking the charger on the installation backplane can prevent theft.
Applications
This charging pile is designed to withstand variable weather conditions for installation inpublic/residential locations including:
Along highway travel stops
Federal and municipal buildings
Charging stations and charge service providers
Airports and parking lot around
Urban Parking lot
EV rental operator
Supermarkets and shopping malls
